HOW TO INSTALL A IN DASH STEREO

Instructions

Difficulty: Challenging

Things You’ll Need:

• Screwdriver
• Wiring harness
• Wrench/socket
• Installation kit
• In-dash DVD player

Step1

Open the hood of the car and disconnect the battery. You can disconnect the negative cable only and still be safe, but it's best to disconnect both the positive and the negative cable.

Step2

Using the proper screwdriver, take out the screws holding the factory stereo in your car's dashboard, then remove the stereo from the dash. You may have to remove parts of the dash to take the stereo out.

Step3

Carefully remove the connectors from the back of the stereo. Check the connectors to make sure they're not broken or dirty.

Step4

You can buy a wiring harness designed for your vehicle at a car audio and video equipment dealer; these are intended for aftermarket installations. Connect the wiring harness to the car's connector. See the wiring harness instructions for the proper connection.

Step5

Insert the in-dash DVD player in the aftermarket installation kit head unit. All dashboards are different, so you must buy an installation kit that matches the make of car.

Step6

Connect the other end of the wiring harness to the back of the DVD player. Connect the antenna cable to the antenna input on the back of the DVD player.

Step7

Insert the DVD player and the installation kit in the car's dash. Put in any screws that are required and replace any dash panels that you removed.

Step8

Replace the battery cables and make sure they are tightened. Close the hood and turn on the car. The in-dash DVD player panel will light up if the installation was successful.